INTERNATIONAL
`STANDARD
`
`ISO
`8117
`
`Second edition
`2003-02-15
`
`Textile machinery — Knitting
`machines — Nominal diameters of
`circular machines
`
`Matériel pour l'industrie textile — Machines à tricoter — Diamètres
`nominaux des machines circulaires
`
`
`Reference number
`ISO 8117:2003(E)
`
`© ISO 2003
`
`iTeh STANDARD PREVIEW
`(standards.iteh.ai)
`ISO 8117:2003
`https://standards.iteh.ai/catalog/standards/sist/cf35e341-cb08-4522-83c1-
`8ea3d0b8c846/iso-8117-2003
`
`Skechers EX1064
`Skechers v Nike
`
`
`STANDARD
`
`ISO
`8117
`
`Second edition
`2003-02-15
`
`Textile machinery — Knitting
`machines — Nominal diameters of
`circular machines
`
`Matériel pour l'industrie textile — Machines à tricoter — Diamètres
`nominaux des machines circulaires
`
`
`Reference number
`ISO 8117:2003(E)
`
`© ISO 2003
`
`iTeh STANDARD PREVIEW
`(standards.iteh.ai)
`ISO 8117:2003
`https://standards.iteh.ai/catalog/standards/sist/cf35e341-cb08-4522-83c1-
`8ea3d0b8c846/iso-8117-2003
`
`Skechers EX1064
`Skechers v Nike
`
`
`
`ISO 8117:2003(E)
`
`PDF disclaimer
`This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
`shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
`downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
`accepts no liability in this area.
`Adobe is a trademark of Adobe Systems Incorporated.
`Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
`parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
`the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.
`
`© ISO 2003
`All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
`electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
`ISO's member body in the country of the requester.
`ISO copyright office
`Case postale 56 • CH-1211 Geneva 20
`Tel. + 41 22 749 01 11
`Fax + 41 22 749 09 47
`E-mail copyright@iso.org
`Web www.iso.org
`Published in Switzerland
`
`ii
`
`© ISO 2003 — All rights reserved
`
`iTeh STANDARD PREVIEW
`(standards.iteh.ai)
`ISO 8117:2003
`https://standards.iteh.ai/catalog/standards/sist/cf35e341-cb08-4522-83c1-
`8ea3d0b8c846/iso-8117-2003
`
`Skechers EX1064
`Skechers v Nike
`
`
`
`ISO 8117:2003(E)
`
`Foreword
`
`ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
`(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
`technical committees. Each member body interested in a subject for which a technical committee has been
`established has the right to be represented on that committee. International organizations, governmental and
`non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the
`International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
`
`International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
`
`The main task of technical committees is to prepare International Standards. Draft International Standards
`adopted by the technical committees are circulated to the member bodies for voting. Publication as an
`International Standard requires approval by at least 75 % of the member bodies casting a vote.
`
`Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
`rights. ISO shall not be held responsible for identifying any or all such patent rights.
`
`ISO 8117 was prepared by Technical Committee ISO/TC 72, Textile machinery and machinery for dry-
`cleaning and industrial laundering, Subcommittee SC 3, Machinery for fabric manufacturing including
`preparatory machinery and accessories.
`
`This second edition cancels and replaces the first edition (ISO 8117:1986), which has been technically
`revised.
`
`© ISO 2003 — All rights reserved
`
`iii
`
`iTeh STANDARD PREVIEW
`(standards.iteh.ai)
`ISO 8117:2003
`https://standards.iteh.ai/catalog/standards/sist/cf35e341-cb08-4522-83c1-
`8ea3d0b8c846/iso-8117-2003
`
`Skechers EX1064
`Skechers v Nike
`
`
`
`iTeh STANDARD PREVIEW
`(standards.iteh.ai)
`ISO 8117:2003
`https://standards.iteh.ai/catalog/standards/sist/cf35e341-cb08-4522-83c1-
`8ea3d0b8c846/iso-8117-2003
`
`Skechers EX1064
`Skechers v Nike
`
`
`
`INTERNATIONAL STANDARD
`
`ISO 8117:2003(E)
`
`Textile machinery — Knitting machines — Nominal diameters of
`circular machines
`
`1 Scope
`
`This International Standard specifies the nominal diameters of circular knitting machines and the numerical
`designations corresponding to the size of the machines. It is applicable to small- and large-diameter circular
`knitting machines and to sinker machines.
`
`2 Normative references
`
`The following referenced documents are indispensable for the application of this document. For dated
`references, only the edition cited applies. For undated references, the latest edition of the referenced
`document (including any amendments) applies.
`
`ISO 7839, Textile machinery and accessories — Knitting machines — Classification and vocabulary
`
`ISO 8188, Textile machinery and accessories — Pitches of knitting machine needles
`
`3 Nominal diameters and numerical designation
`
`For classifications and the vocabulary of knitting machines, see ISO 7839; for needle pitches, see ISO 8188.
`Table 1 specifies the nominal diameter, in millimetres, and the numerical designation applicable to each
`machine size.
`
`© ISO 2003 — All rights reserved
`
`1
`
`iTeh STANDARD PREVIEW
`(standards.iteh.ai)
`ISO 8117:2003
`https://standards.iteh.ai/catalog/standards/sist/cf35e341-cb08-4522-83c1-
`8ea3d0b8c846/iso-8117-2003
`
`Skechers EX1064
`Skechers v Nike
`
`
`
`ISO 8117:2003(E)
`
`Table 1 — Circular knitting machines
`
`Small circular
`Large circular
`knitting machines
`knitting machines
`Designation
`Nominal diameter Designation Nominal diameter
`57
`2 1/4
`178
`7
`64
`2 1/2
`190
`7 1/2
`70
`2 3/4
`203
`8
`76
`3
`229
`9
`83
`3 1/4
`254
`10
`89
`3 1/2
`279
`11
`95
`3 3/4
`305
`12
`102
`4
`330
`13
`108
`4 1/4
`356
`14
`114
`4 1/2
`381
`15
`121
`4 3/4
`406
`16
`127
`5
`432
`17
`133
`5 1/4
`457
`18
`140
`5 1/2
`483
`19
`146
`5 3/4
`508
`20
`152
`6
`533
`21
`165
`6 1/2
`559
`22
`584
`23
`
`610
`24
`
`635
`25
`
`660
`26
`
`711
`28
`
`762
`30
`
`(787)
`(31)
`
`813
`32
`
`(838)
`(33)
`
`864
`34
`
`914
`36
`
`965
`38
`
`1 016
`40
`
`1 067
`42
`
`1 118
`44
`
`1 168
`46
`
`1 219
`48
`
`1 270
`50
`
`1 321
`52
`
`1 372
`54
`
`1 422
`56
`
`1 473
`58
`
`1 524
`60
`
`Values shown in brackets should be avoided as far as possible.
`
`2
`
`
`
`
`© ISO 2003 — All rights reserved
`
`iTeh STANDARD PREVIEW
`(standards.iteh.ai)
`ISO 8117:2003
`https://standards.iteh.ai/catalog/standards/sist/cf35e341-cb08-4522-83c1-
`8ea3d0b8c846/iso-8117-2003
`
`Skechers EX1064
`Skechers v Nike
`
`
`
`iTeh STANDARD PREVIEW
`(standards.iteh.ai)
`ISO 8117:2003
`https://standards.iteh.ai/catalog/standards/sist/cf35e341-cb08-4522-83c1-
`8ea3d0b8c846/iso-8117-2003
`
`Skechers EX1064
`Skechers v Nike
`
`
`
`ISO 8117:2003(E)
`
`ICS 59.120.40
`Price based on 2 pages
`
`© ISO 2003 — All rights reserved
`
`iTeh STANDARD PREVIEW
`(standards.iteh.ai)
`ISO 8117:2003
`https://standards.iteh.ai/catalog/standards/sist/cf35e341-cb08-4522-83c1-
`8ea3d0b8c846/iso-8117-2003
`
`Skechers EX1064
`Skechers v Nike
`
`
Accessing this document will incur an additional charge of $.
After purchase, you can access this document again without charge.
Accept $ Charge
Still Working On It
This document is taking longer than usual to download. This can happen if we need to contact the court directly to obtain the document and their servers are running slowly.
Give it another minute or two to complete, and then try the refresh button.
A few More Minutes ... Still Working
It can take up to 5 minutes for us to download a document if the court servers are running slowly.
Thank you for your continued patience.
This document could not be displayed.
We could not find this document within its docket. Please go back to the docket page and check the link. If that does not work, go back to the docket and refresh it to pull the newest information.
Your account does not support viewing this document.
You need a Paid Account to view this document. Click here to change your account type.
Your account does not support viewing this document.
Set your membership
status to view this document.
With a Docket Alarm membership, you'll
get a whole lot more, including:
- Up-to-date information for this case.
- Email alerts whenever there is an update.
- Full text search for other cases.
- Get email alerts whenever a new case matches your search.
One Moment Please
The filing “” is large (MB) and is being downloaded.
Please refresh this page in a few minutes to see if the filing has been downloaded. The filing will also be emailed to you when the download completes.
Your document is on its way!
If you do not receive the document in five minutes, contact support at support@docketalarm.com.
Sealed Document
We are unable to display this document, it may be under a court ordered seal.
If you have proper credentials to access the file, you may proceed directly to the court's system using your government issued username and password.
Access Government Site
